A multipoint heater with electronic control, at an attractive price. A power range from 9kW to 21kW.
In a nutshell:
- multi-point heater
- wide power range from 9kW to 27kW/400V
- power switch
- electronic control
Hot water only when you need it
Flow-through heaters are the most energy-efficient way of getting hot water. They consume electricity only when the water flows, while the consumption of heated water is not limited by the capacity of the tank.
Multi-point heater at a good price
One of the advantages of the KDE3 heater is the ability to heat water at multiple points at a low purchase price.
Electronic control – get the comfort of use
First of all, the electronic control means precise and comfortable adjustment of the water temperature. The temperature range is from 30°C to 60°C. The temperature can be set with an accuracy of 1°C.
4 power ranges in one device
The solutions applied enable selecting the maximum power of the heater (applies to devices with power from 9kW to 27kW). The maximum power can be changed using microswitches located inside the heater.
Reheating pre-heated water allows the heater to interact with other devices
The inlet water temperature can be up to 60°C. This solution allows the heater to interact with another heat source and preheat water with the use of, for example, a solid fuel boiler in cooperation with a hot water tank.
|Energy efficiency class||A||A||A|
|Energy efficiency label||Download||Download||Download|
|Product data sheet||Download||Download||Download|
|Heat capacity||9/11/12/15 kW||17/18/21/24 kW||27 kW|
|Power supply||400V 3N~||400V 3N~||400V 3N~|
|Ciśnienie wody (MPa)||0,1 - 1,0||0,1 - 1,0||0,1 - 1,0|
|Water pressure Δt=30
L x W x H (mm)
|245 x 126 x 440||245 x 126 x 440||245 x 126 x 440|
error Your review appreciation cannot be sent
feedback Report comment
check_circle Report sent
error Your report cannot be sent
Write your review
check_circle Review sent
error Your review cannot be sent